The full text is:
"...Did you know that the new PGA (Pin Grid Array) AMD Athlon(tm) and AMD Duron(tm) processors have very different thermal specifications than any preceding AMD processor? Due to these differences, the AMD Athlon and AMD Duron processors should NEVER be run without a heatsink, not even for a few seconds. Doing so will cause the processor to overheat and fail immediately, resulting in permanent damage. While testing a processor by booting it up for several seconds without a heatsink installed may be common industry practice, it should never be attempted with the new PGA AMD Athlon and AMD Duron processors...
"Additionally, the new exposed flip-chip design of the PGA AMD Athlon and AMD Duron processors requires a clip load between 12 and 24 pounds (typically 16 pounds), a load that may not be met by most older heatsink designs. A thermal compound, such a thermal grease or phase-change material, must always be applied between the processor and heatsink as well. Typically, AMD recommended heatsinks will include the thermal compound. If the thermal compound must be purchased separately, a list of suggested compounds can be found in the 'AMD Thermal, Mechanical, and Chassis Cooling Design Guide' "
A topikra egyébként én is fújolok, mi fogyasztók vagyunk, az Isten szerelmére! Ők nyalják ki a mi seggünket, ne mi az övéket.
(Mielőtt engem is elküldenétek: jelenleg Duron850 ketyeg a gépben és -úgy néz ki- a héten érkezik az 1,4-es Athlon
. Ma frissítettem BIOS-t, jó móka volt, egy fél doboz cigi meg az összes körmöm ráment az izgalom miatt.)
